Layers
Upload a G-code file to see layers
Upload a .gcode file to preview and modify it
If blank, the offset applies from the start layer to the end of the print.
Positive = raise nozzle, negative = lower nozzle. Adjusts all Z moves within the specified layer range.
Insert any custom G-code at a specific layer or at the end of the file. Each line will be inserted as-is.
Detection
4mm
Detected Holes
Click "Detect Holes" on a layer with the Visual view active
Insert Configuration
Recovery mode reprints from a specific layer at the bed surface. Print it flat, then glue the two halves together.
Enter either the layer number or measure the failed print height with calipers. The other field updates automatically.
Z-heights are shifted so the resume layer prints at the original first-layer height. Feedrates on the resume layer are overridden with first-layer speeds for bed adhesion.
Fan Rules
Fan Curve
Actions
Firmware
Base K-Factor
Default for all types
Per-Feature K-Factor
Load a file to see motion types
Calibration Pattern
Actions
Not loaded
Balanced
Severity Thresholds
Load a G-code file and run analysis
Modifications
0
No modifications added yet